EDGEDAM SE is a fully-cured silicone rubber extrusion.
EDGEDAM SE is used to control resin flow during a component cure cycle. This retains the resin within the component laminate affording better resin content control and avoiding potentially expensive damage to vacuum valves, pumps, etc. EDGEDAM SE can be used twith any resin, adhesive, or prepreg system up to 550F (287C).
|Hardness (Durometer)||60 +/- 5 Shore A|
|Tensile Strength||11450 psi|
The above values are “Typical Values” which have a nominal range about them and are not intended for specification purposes).
1/2″ x 3/8″ x 50′ roll
Other sizes available upon request. Minimums may apply.